Visit our community sponsor
Thanks:
0
Likes:
0
-
IRS Pin Drive Trigo fitment problem...
Hello all, and thank you in advance for any helpful replies. I'm assembling a pin drive width IRS and it's time to mount the wheels (15" Trigo FIAs.) When I slide the Trigo adaptor onto the new Ford Racing 5-lug kit car IRS hub, the studs are so long that the pin nuts cannot be tightened fully onto the adaptor. I have included pictures. Am I missing something here? Is a spacer required? I've seen no mention of this anywhere. I'm assuming it's operator error at this point. Ideas?
20150313_134440.jpg20150313_134420.jpg
-
Senior Member
First, you're going to want to put your brake rotors on. Also, you're going to need to grind down/cut off the non-threaded parts of the lugs.
Build Blog
#8203, carbed 427W (611 hp), TKO 600, IRS
Delivered: May 27, 2014
Mechanically "Complete": October 1, 2014
-
Thanks, Bren! Trigo gave me a phonecall which stated just that. Apologies. I appreciate it.
-
Member
I'm running a solid rear axle and getting ready to order my rear axles. What length studs are required for the pin drive adapters to work?
-
Senior Member
I don't remember what the length needed is, but I do remember that they aren't manufactured by anyone. I checked everywhere. You have to cut them to length.
Build Blog
#8203, carbed 427W (611 hp), TKO 600, IRS
Delivered: May 27, 2014
Mechanically "Complete": October 1, 2014
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Visit our community sponsor