was gone for work for a bit and now i'm back trying to get Tino the info he needs for my gauges. I got the resistance number for him on all the sensors except....... my fuel gauge. That wire, which I'm getting my reading from is the one that runs from the gas tank all the way through the tunnel and ends at the computer module. Sooooo to get no reading must mean it is not connected to the sensor. My buddy who works on a lot of corvettes says those sensors are fairly common to go out and that I should've put a new one in to begin with. He also said its not uncommon to install them incorrectly to give a bad reading ( float stuck up or down or something I can't remember) Soooo I'll be dropping the passenger side tank and taking a look . Good news is I haven't put the panels back up and its easy to get to. 2 steps forward..... I step back lol