Visit our community sponsor
Thanks:
0
Likes:
0
-
Senior Member
Pivot Ball Setting for 351W / Quicktime Bell / TKO600
I've been scanning a lot of old threads but I'm not sure I'm understanding how to do the initial setup on the ball pivot correctly. I think I basically need to get the clutch fork as far back as possible with the throwout bearing just touching the spring fingers on the pressure plate. The picture below shows the position of the fork with the pivot ball screwed out about as far as I can get it (any further and the fork is gonna hit the pressure plate hat). This look about right?
clutch_fork.jpg
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Visit our community sponsor