Visit our community sponsor
Thanks:
0
Likes:
0
-
Front control Arms And Spindles
Got to the point where I was installing the spindles. The upper ball joint threaded rod is supposed to fit in the top of the spindle and the lower one the same way capped both off with the castle nuts & cotter pins. The problem is the upper ball joint rod seems too short. When I slide it into the top of the spindle, not enough of it is exposed making it impossible to thread the castle nut.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Visit our community sponsor