upgrade winter rebuild RTTavi racing 09

[R.T. Tavi]

got my heads and started puttting the engine back together. working on the chassis too.IMG_3911a.JPGIMG_3931a.JPG

also have a question about the front brake lines - is there a fitting that screws straight into the caliper and goes to a -4? (that replaces the banjo fitting)

[johngeorge]

The thread size is 10mm x 1.0 for the caliper banjo.. I'm sure they sell an AN fitting for that.

[mhoward1]

It's looking good, but where is the outside head/shoulder protection diagonal bar?

[FFRSpec72]

I used a # 4 hose with a 90 degree from F-Panel and then a female fitting at other end which attached to banjo fitting.

[R.T. Tavi]

The roll cage mods were approved in advance by NASA, Factory Five and SCCA. If you look at Scott McKay's car, he doesn't have them either.

BTW, I found an Earl's fitting for the calipers (592042ERL).

[mhoward1]

I do like the Front supports and halo section. I think that's a great solutions.

Glad you also found a fitting. Any events planned yet?

[R.T. Tavi]

Looks like June Grattan, Gingerman Then maybe Atlanta if things go well and gas prices