Here is my current plan for grounds ... that is the kind you want or need to have.

I found these buss bars from DelCity which have ground connections at both ends of the bar with 6 spots to attach grounds from the loads (I anticipate actually putting more than one on a spot if need be):



Here is the installation for the grounds at the rear of the car. I attached it to the rear IRS cage support:



After installing the bar I used 8 gauge power wire left over from the power cables to attach the buss bar at both ends to the chassis giving the circuits attached two paths to ground.





A little dielectric grease was applied as well

Here is the finished version with the cover installed:



I then added some braided wire wrap to cover up the "red".



I have ordered 3 more of the buss bars to use in the dash and front of the car.

Please let me know if you all see any issues with the plans here ...

Carl