Visit our community sponsor
Thanks:
0
Likes:
0
-
Senior Member
Coyote Harness - Last few remaining wires...
Wiring is nearly finished, but would appreciate a little feedback on the last few wires that I have to find a home for. There is a single coil of wires labelled as the "Sending Units / Electronic Choke" that I have in the engine compartment.
The wires in that bundle are as follows, followed by my thoughts:
1.LT BLUE- OIL TEMP: Not sure where this goes or if it is needed
2. GREY - OIL PRESSURE: Not needed as there is a direct plug from the Oil Pressure sensor to the dash gauge
3. DK BLUE - WATER TEMP: Not needed as there is a direct plug from the temp sensor to the dash gauge
4. PURPLE - COIL/TACH: Not needed, as the tach is being driven by the Coyote computer through the Coyote Harness
5. TAN - ELECTRIC CHOKE: Don't think I need this, but not positive (need feedback)
6. DK GREEN - FAN THERMO SWITCH: Not Needed, as the cooling fan is being driven by the Coyote computer through the Coyote Harness
Thanks in advance. We hope to get a first start tomorrow, so pretty anxious to figure out these last few wires.
Last edited by Slider; 10-19-2012 at 08:45 PM.
Reason: fixed spelling error in title
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Visit our community sponsor