Visit our community sponsor
Thanks:
0
Likes:
0
-
Senior Member
Front turn signal connector assembly trouble
The connectors I had to assemble for the rear turn signal/reverse light went together just fine, but the front turn signal connectors don't seem to have the right pieces. The connector is gray and has yellow grommets. I crimped the terminals on just fine. But when I go to slip them into the connector, they seem much too long/large to fit. Unlike the rear connector, where the terminals slipped in and clicked into place, these don't even come close to snapping in.
Anyone else having this trouble?
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Visit our community sponsor