Made it by the shop today. Bodywork is starting now. Will need to be purchasing paint within the next two weeks and Kory says I need to set aside a couple days to be out at the shop during the masking of the Star....

IMG_6493.jpg

IMG_6498.jpg

IMG_6503.jpg

IMG_6504.jpg

IMG_6505.jpg

IMG_6507.jpg

As I had previously mentioned, due to cost, I ended up going the route of 3D printing the Hood Scoop Vent out of Aluminum instead of machining...I just received these photos from my guy and must admit, from the photos alone...I am pretty impressed! Hope to have them in my hand by the end of the week...

Hood Vent Alum - 1.jpg

Hood Vent Alum - 2.jpg

Hood Vent Alum - 3.jpg