Russ Thompson Turn Signal wiring

[Jdav]

I am wiring up the Russ Thompson Turn Signal and using the momentary stalk button to activate hi beam/low beam & Flash to pass with a Ron Francis harness.
I've looked through all of the diagrams provided and others I have found, but still unsure. Especially when it comes to what wires are feeding each relay.
Would appreciate confirmation from you guys that I am doing this right:

Feed:
Connect the RF gray TURN FLASHER FD wire to the Russ Thompson common larger Black wire

Left Turn:
Connect the RF green/yellow/green (LEFT FRONT TURN/LEFT REAR TURN/LEFT DASH IND LIGHT) bundle to the Russ Thompson Black-white wire

Right Turn:
Connect the RF blue/white/blue (RIGHT FRONT TURN/RIGHT REAR TURN/RIGHT DASH IND LIGHT) bundle to the Russ Thompson Black-green wire



Flasher on/off toggle switch:
Connect the RF pink HAZARD FLASHER wire to one spade of the switch
Add diodes to each then join and connect the RF blue RIGHT FRT TURN and green LEFT FRT TURN wires to the other spade of the switch


VW Relay:
Split out and connect the RF brown HI BEAM IND wire to 56a
Connect the RF red LOW BEAM wire to 56b
Connect the RF blue HDLT SW>DIM SW to both 56 and 30
Run a new wire from S to a diode, merge with a wire from 85 of Bosch relay and connect to one of the Russ Thompson smaller black wires



Bosch Relay (i am also using a relay plug):
Connect the other split of the RF brown HI BEAM IND wire to 30
Merge a wire with the one coming from S of the VW relay and connect to one of the Russ Thompson smaller black wires
Connect RF brown HIGH BEAM wire to both 86 and 87
87a is not used



Russ Thompson:
Ground the other small black wire