I received my CNC triple and built a bracket for it. The bracket needs to be finish cleaned and powdercoated. I used an engraver to mark the resevoirs by where they feed to as it will be hard to tell after the body goes on. The green bolts are temporary.
I installed the heater in the firewall and decided that it needed a brace.
I was cleaning up the other night and found this near the front of my car. It appears to be a set screw with an allen drive. It is stainless steel. I cannot find a home for it anywhere on the car. Does anyone recognize it. My project is not the only thing going on in my shop so it could be from something else. Or it could be a prank from one of my boys. They have a tendency towards tearing down a motor or some other project and leaving the piles around the shop to get in my way. I have been known to toss a random bolt or other part into their pile just to watch the consternation when they can't figure out where it goes.