I took this off my 8.8 straght axle. Do I re use this flange, do I need to get a different one, or does one come with the kit?
Thanks!
Visit our community sponsor
I took this off my 8.8 straght axle. Do I re use this flange, do I need to get a different one, or does one come with the kit?
Thanks!
Started dreaming of a Cobra around 1987
Purchased Complete Kit 6/9/2017, Delivered 9/4/2017, Rolling Chassis 3/30/2018, Engine Dyno'ed 3/4/2022, Engine installed 8/27/2022
Click here for my build thread
Serial #9158
Design Engineer at BluePrint Engines
In case you need any, here are some instructions on the 8.8 rear end. (You'll need an in/lb torque wrench for figuring out the pre-load, after replacing the crush washer).
https://performanceparts.ford.com/do...htM-4209-8.pdf
Last edited by AC Bill; 02-09-2018 at 07:06 PM.
Started dreaming of a Cobra around 1987
Purchased Complete Kit 6/9/2017, Delivered 9/4/2017, Rolling Chassis 3/30/2018, Engine Dyno'ed 3/4/2022, Engine installed 8/27/2022
Click here for my build thread
Serial #9158
Design Engineer at BluePrint Engines