instructions have u cut 5/8 in off ea of the brake masters, then assemble. Problem is you need the 5/8 u cut off to reach the coupler between the 2.
Now I have 2 trashed brake masters???
Visit our community sponsor
instructions have u cut 5/8 in off ea of the brake masters, then assemble. Problem is you need the 5/8 u cut off to reach the coupler between the 2.
Now I have 2 trashed brake masters???
This is one of those areas where the FFR manual could be improved. It's best to fit them up and then trim as needed, a little bit at a time. The good news is you can buy a rebuild kit for the MC relatively inexpensively (~$26 at Summit) that includes a new pushrod.
MkIV Roadster build: Gen 2 Coyote, IRS, TKO600. Ordered 10/24/18. Delivered 1/29/19. Engine installed 8/8/21. First start 9/12/21. First go-kart 9/17/21. Off to paint 4/11/22. Back from paint 12/30/22. Build thread here.
When I cut mine I still threaded them to the bottom. Can you post pics?
https://thefactoryfiveforum.com/show...tures-in-posts
You should get to know the pic gallery, and use it to include images when you post questions. It gives clarity to what you are asking about (I'm a visual guy).
HTH,
FFR 5369 Pin Drive, IRS, Trigos, Torsen, Wilwoods, FMS BOSS 302 "B" cam , Mass-flo. CA SB100 (SPCN) Registered
Delivered 4/23/06. "Finished" 4/2012 (still not done!)