-
Exeter Rhode Island Coupe-R Build
Hello all, I'm an advanced composites boatbuilder with a small shop in Rhode Island, sort of a SpeedShop for racing sailboats. It's been a life long dream to build a car. A customer/friend brought his R&D (Shell Valley bought the molds) Daytona Coupe build in for paint. There were some symmetry issues with the tail end. So much work was done it was clear the car needed to be retooled mid roof aft. I was tempted to tool the entire car but I'm not 50 anymore so just tooled the rear clip. The car is a 90" wheelbase sitting on a Cobra Chassis. I couldn't find time to source chassis, etc and build a car that I could easily register. It was a fleeting dream.
I placed the order after a guided tour with David Lindsey.
Gen 3 Coupe R complete kit
White Powdercoated frame
Coupe Platinum Gauges
302-351 engine/trans mount
302 headers
31 spline 2015 irs driveshaft
Body w/traced cut-outs
Aluminum racing seat
Power Steering Components
front Lower Arms
Coupe Competition 2015 irs Parts
R-Coupe Nose side ducts
R-Coupe rear side cutouts
2015 irs swaybar comonents
EFI in-tank fuel system
Hydraulic Clutch master Cylinder kit
BluePrint 347 TKX 5 speed
Last edited by Peter Ross; 12-15-2022 at 08:26 AM.
-
Post Thanks / Like - 0 Thanks, 1 Likes