Hello all.

I am almost done wiring my dash and have a question. The optional padded dash with glovebox I have has pre cut holes but I need to cut a few more for the toggle switches (Hazards, turn signals etc). Lots of post for dash cutting the bare aluminum but nothing on the finsihed dash. I need the smaller 1/2 inch holes but am reluctant to take a drill to it as there is no going back. Has anyone cut the new dash and if so, how did it work out? Did you use a hole saw, drill bit, etc? Did you cut from the back or front? Sorry if this is a basic question but i just don't want to mess it uo especially the front vinyl. thanks.