Boig Motorsports

Visit our community sponsor

Thanks Thanks:  12
Likes Likes:  19
Results 1 to 40 of 88

Thread: Getting ready to pull trigger on build kit - got questions - any help appreciated

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Senior Member Fman's Avatar
    Join Date
    Jan 2020
    Location
    State of Jefferson
    Posts
    1,285
    Post Thanks / Like

    Getting ready to pull trigger on build kit - got questions - any help appreciated

    Here is what I am planning on ordering in near future:

    Mk4
    Coyote engine w/TK0600 trans
    IRS suspension/rear end
    Leather seats
    Power steering kit
    17" wheels
    Going with base disc brake kit (No wildwood)
    Wiper kit (to pass CA inspection for SBC-100, prob will never use)
    Heater
    Adding heated seats
    Passenger side rollbar
    Floor mats
    Sun visor
    Wind wings

    Anything else someone would recommend?

    Few questions I have...

    Power brakes? What are guys doing to add power brakes? is it necessary or is the wildwood pedal box adequate?
    Roll bars? Someone mentioned some guys cut them down 1"? different vendor that sells a shorter roll bar?
    For guys in CA, do you need wipers to pass the inspection? I would really not like to buy them but also dont want to fail because they were never installed.
    Where should I buy my engine/trans? Is it best to go with Factory Five?

    Thanks for any feedback...
    Last edited by Fman; 01-29-2020 at 04:41 PM.

  2. Likes Aircontroller liked this post

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

FFMetal

Visit our community sponsor