Folks,

I posted this picture on my build thread and did not seem to get any response, so I am posting here to maybe get some more eyes on the post.

As I waited for help to get the body off the frame and put on my elevated platform, I decided to look at the UCA and at least do some dry fitting and setup. I reversed the outboard fittings for the balljoint holders. Please let me know if I set the UCAs up right.
Front UCA .jpg
Left Side =DS; Right Side = PS; Top/Up = FWD

I have not done the rough alignment yet and cut the rear leg yet as I want to ensure the UCA orientation is correct. The Mevotech ball joints seemed to spin in fairly easily by hand, so I removed them until ready for install.

Thanks for the help.

Bill