![FormaCars](https://thefactoryfiveforum.com/attachment.php?attachmentid=62553&d=1483735916)
Visit our community sponsor
![Thanks](https://thefactoryfiveforum.com/dbtech/thanks/images/thanks.png)
Thanks:
3
![Likes](https://thefactoryfiveforum.com/dbtech/thanks/images/likes.png)
Likes:
22
-
Senior Member
2x on keeping the back wall smooth... Thinking back on it, if I was to do it again, I'd probably tear out little nubs (halfway through) of the sheet padding I used over each rivet head, then glue it in place - smooth side out.
The only place where the rivet heads printed through that's visible is between the seats... nearly all others are concealed.
John D. - Minneapolis 'Burbs
1965 El Camino - LT-1, 4L60e, 4wh discs, SC&C susp.
2013 F-150 Platinum - Twin Turbo 3.5
2018 Mk4 Roadster w/ Coyote - #9365 - Build Thread Delivery 7/3/18, 1st Start 1/4/19, 1st Road Mile 5/5/19, Legal 6/18/19, In Paint 2/25/21, Done (?) 4/2021
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
![FFMetal](https://thefactoryfiveforum.com/attachment.php?attachmentid=195371&d=1707243047)
Visit our community sponsor