Visit our community sponsor
Thanks:
0
Likes:
0
-
Senior Member
"the older pin drive half shafts I recieved were like this...the c clip was obliterated and the bearing was pushed back and stuck on the axle. I had to pull it off with a gear puller"
If the bearing was all the way back, stuck on the axle, then of course the bearing would be too short, and slip out of the housing.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Visit our community sponsor