Pics of outside coolant tubes

[Power Surge]

I know the GTM forum isn't very active anymore, but....

If anyone seeing this did the outside the frame coolant tubes, post up pics of your setup! Would like to see some different routing ideas.

Calling Crash here too.... as I understand he pioneered this mod.

[J R Jones]

My chassis is the 818 and I have installed a Ferrari Dino replica body. The Dino body mounts higher than the 818 giving me the opportunity to run the coolant tubes below the rocker panels.
The hose bibs come up into the body near the F & R wheel wells. This made routing into the front compartment neater and opened up the footwells. Obviously better heat exchange and less heat into the interior. I would have used finned extrusions but could not find that configuration. I welded mount bosses and drains into the bottom of the tubes.
Semi gloss black makes them less obvious.
jim

IMG_0119 (1).jpg
IMG_0118 (1).jpg

[ohmygosuness]

You probably have Gen I. Mine is Gen II, so it's slightly different. (Idea inspired by Crash)
radiator 180 piping.jpg
radiator driver pipe1.jpg
radiator driver pipe2.jpg
radiator footwell.jpg
radiator pipe passenger side.jpg

[beeman]

I'm running them just inside the rear aluminum firewalls, in enclosed insulated aluminum housings. It's the most direct path from and to the water pump.

20240614_150243.jpg20240613_171025.jpg

[Shoeless]

I'm running them just inside the rear aluminum firewalls, in enclosed insulated aluminum housings. It's the most direct path from and to the water pump.

20240614_150243.jpg20240613_171025.jpg

Any concern with the passenger side going right under the fuel tank? Or do you plan on insulating it with something?