Forte's

Visit our community sponsor

Thanks Thanks:  0
Likes Likes:  0
Results 1 to 2 of 2

Thread: Dust boot ring install

  1. 05-04-2015, 10:59 PM #1
    TouchStone
    TouchStone is offline
    Senior Member TouchStone's Avatar
    Join Date
    Sep 2014
    Location
    Dallas, TX
    Posts
    512
    Post Thanks / Like
    Blog Entries
    1

    Dust boot ring install

    How are you supposed to install the boot ring for the piston dust boot? I cannot get the ring to set right without tearing the boot.

    caliper.JPG
    818S Chassis #288 2.5L 323hp
    Ordered: 9/19/14 Received Kit: 11/2/14 First Start: 5/31/15 First Drive: 6/7/15 Registered: 3/10/2016 Completed: 2/10/2017
    Status: Complete Build Thread Sold 9/22/2017
    joshuajach.com
    Reply With Quote Reply With Quote
  2. 05-05-2015, 08:20 AM #2
    Hindsight
    Hindsight is offline
    Moonlight Performance
     Hindsight's Avatar
    Join Date
    May 2014
    Location
    Atlanta
    Posts
    3,402
    Post Thanks / Like
    I didn't have an issue with it. The rings are split. Put one of the ends of the ring in the groove, then hold the other end and press it down from the installed end, slowly going all around the piston to the end your holding. If that makes sense.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Replica Parts

Visit our community sponsor