I got the Daytona back from the body shop. It was there for them to finish gap the doors and nose. No I am going to fit the exhaust and at some point the side windows. Then I will remove the body and give it back to them to finish and paint.
Here are a few pics of the exhaust install. Both pipes fit pretty decent but did need a little help. Both side pipes got a Breeze shim to move the end of the pipe closer to the body by 1 inch. also i needed to use 5/16 bolts to bolt them up so I could rotate the side pipe up a bit to make it parallel with the body. The end result is a perfect fitting pipe.

Here are a couple of pics before the shim and smaller bolts.







and here is a pic after the shim and smaller bolts.




and a pic of the hanger at the back of the pipes.



I have read a lot of complaints about the side pipe fitment, but i didn't find them too bad. Certainly not any worse than the Cobra.

I also started getting the Coyote wiring and computer in place. I found that with a very minor mod to the engine harness i could get the computer mounted into the firewall.
Seems like a good spot for it and its out of the way. No interference behind the dash either.





The fuse box for the engine will also be mounted inside the car.