Boig Motorsports

Visit our community sponsor

Thanks Thanks:  21
Likes Likes:  18
Results 1 to 40 of 102

Thread: FLFrank's '35 Hot Rod Truck Build

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 03-29-2020, 11:44 AM #11
    FLFrank35
    FLFrank35 is offline
    Senior Member FLFrank35's Avatar
    Join Date
    May 2019
    Location
    Viera, FL
    Posts
    261
    Post Thanks / Like
    Blog Entries
    1

    Another truck update

    Installed the floor, driveshaft, exhaust system...

    IMG_0350.JPG IMG_3655.JPG IMG_3660.JPG IMG_3663.JPG IMG_3670.JPG 60607315508__1E0A8EA7-0F3C-4180-84A1-4CCB6DBD6585.JPG
    IMG_0387.JPG IMG_0388.JPG IMG_0379.JPG IMG_0395.JPG Side note: The manual says to bolt the exhaust pipe mounts through the frame, but the problem I found is that the bolt would be protruding through the cab floor. So I used 3/4" long, stainless steel, sheet metal, flanged screws to attach the mounts to the bottom of the frame tubes. Also, most of the pipes are 2-1/4" and the supplied brackets fit fine, but the turn-down tips are 2-1/2" so I got some good hanging brackets from Summit...and I undercoated the bottom with Dupli-Color Bed Armor.
    Last edited by FLFrank35; 03-29-2020 at 12:02 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

FFMetal

Visit our community sponsor