Ninjanick's 818S Build Thread

[Bob_n_Cincy]

I'm looking at the isolator you linked and it's a two piece design. Does that mean you don't sandwich the pieces together? Just basically drive a bolt through and done? It's supplied with one large washer for support in case the isolator fails. There's a recessed end where the bushing sits. Is the flat washer meant to install on that end?

Here is a drawing that describes how they are used.

http://www.avproductsinc.com/center-...ce-mounts.html

On the tach, I was unaware that the Evnetics and Manzanita Controllers needed special feedback.
Bob