my kit came with gas pedal but it doesnt match any holes on the steel bracket for the gen 3 can anybody share a picture of theirs or tell me
how yours went in
thanks
Visit our community sponsor
my kit came with gas pedal but it doesnt match any holes on the steel bracket for the gen 3 can anybody share a picture of theirs or tell me
how yours went in
thanks
I assume you are not installing a Coyote engine? I installed a Coyote so I might not be much help, but I know mine came with the bracket on the chassis and then another separate bracket that was stainless steel (maybe aluminum), that doesn't get used with the Coyote pedal. Are you talking about the bracket welded on the frame, or the separate metal bracket?
Cheers,
--jim
Build 1: Gen III Type 65 Coupe, Gen II Coyote
You'll just position the pedal where you want it and drill holes to mount it. That's how it's intended to be installed so you can get it where it's comfortable for you.
Go see P100DHG build thread, post #67. It might help.
Or The Colorade « Coop » build thread, post # 44. Might give you some ideas.
thanks guys for the help ,now i get get plan on were to mount mine
Check out my build I have a table of contents that will guide you in pedal placement and accelerator cable routing. Link is in my signature
P100DHG’s Gen 3 65 Coupe #138 Build Thread - Order Date: Aug 2018 - Delivered: Feb 2019 -
First Start: May 2020 - First Drive: January 2021 - Instagram @SixtyFive_Daytona