Aluminum Fuel Tank by Boyd Welding

[longislandwrx]

I'm kind of leaning back to this route. Maybe I'll add in the little baffles with the 1" holes but not put in the check valves. If I end up needing them later I can add them later.

smart.

Yes as the pumps I have can draw up to 15-18 amps and the controller can handle 20 amps so I was getting failures and had to install a second controller and folks with even single high performance pumps may have amp draw issues

what's your fuel setup? I would think at next to no pressure the draw on the lift pump wouldn't be that high.

Craig,
I like idea #1, but why use a second pump. Use the free jet pump like stock Subaru.

jetpump.jpg

I don't have one of these at my disposal, however a DW200 for the lift pump and install kit is less than $100