Visit our community sponsor
Thanks:
0
Likes:
0
-
Senior Member
A few questions for guys that have used POR-15
I have my old 8.8 straight axle all cleaned up. I used a wire wheel to clean off the rust. It's cleaned to the point where it is down to the shiny metal. I was planning on buying POR-15 to coat it. I have a few questions for those of you that have used POR-15 it before:
1. Will the POR-15 adhere ok with most of the rust being cleaned off?
2. Did you use only the POR-15 rust preventive coating or did you use the whole system, degreaser and metal prep?
3. How much do you suggest buying to cover an axle?
4. Top coat or not to top coat? Can I use a cheaper rattle can paint?
5. Is there another product better suited for this?
Thanks again!
Last edited by Yama-Bro; 02-12-2018 at 04:55 PM.
Started dreaming of a Cobra around 1987
Purchased Complete Kit 6/9/2017, Delivered 9/4/2017, Rolling Chassis 3/30/2018, Engine Dyno'ed 3/4/2022, Engine installed 8/27/2022
Click here for my build thread
Serial #9158
Design Engineer at BluePrint Engines
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Visit our community sponsor