Visit our community sponsor
Thanks:
0
Likes:
0
-
Senior Member
Upper control arm questions...manual, book, and parts don't jive...
I started on the upper control arms this evening, but ran into some conflicting info between the manual, the "How to build Cobra kit cars" book and the parts themselves. So now I have questions:
1. Looking at my arm and comparing to the manual, I think it is assembled wrong. Should the threaded end be flipped the other way?
2. Which mounting holes do I use in the frame? The holes with center lines that are perpendicular to the ground, or the holes that are parallel to the ground? The manual shows it one way and the "How to build Cobra kit cars" book shows it the other way. I am using the spindles that come with the MK4 kit...
Started dreaming of a Cobra around 1987
Purchased Complete Kit 6/9/2017, Delivered 9/4/2017, Rolling Chassis 3/30/2018, Engine Dyno'ed 3/4/2022, Engine installed 8/27/2022
Click here for my build thread
Serial #9158
Design Engineer at BluePrint Engines
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Visit our community sponsor