Visit our community sponsor
Thanks:
256
Likes:
574
-
Senior Member
Originally Posted by
Papa
I positioned my dash (Factory Five padded dash option) so that the steering shaft was centered in the opening then aligned the center top edge with the top of the hoop. I used a small bit to drill through the dash and mark the hoop, then used the larger bit to drill for the nutserts. I used 10-24 stainless screws with stainless finish washers.
Dave
Thanks Papa. That is what I was thinking about doing (I have the same dash). I was just worry it wouldn't leave a room for later adjustment, if needed.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Visit our community sponsor