Visit our community sponsor
Thanks:
2
Likes:
9
-
David aka Ducky2009
Originally Posted by
Straversi
Ducky, before you cut, check to see if the adjusting nut is centered. On one of my UCA assemblies, the adjusting nut was spun down one threaded rod about 1/4" before any threads were engaged on the other rod. I don't know if it would have mad e a difference but it seemed like I would have less adjustment.
-Steve
Steve,
I unbolted the adjusting link from both ends and screwed ends in all the way, then reattached. Still to long to achieve 7 degrees. Not sure what other people are experiencing.
Thanks
David
MK4 Build #9035 Delivered 2/17/17, First Start & Go-Kart 6/2/17, Licensed 9/1/17
Paint - Lightning Blue Metallic, No Hood Scoop, No Stripes
Gen 2 Coyote Engine & TKO-600. Solid Axle, 8.8-3.55, Power Steering, Power Brakes, Dual Roll Bars
Heater and Glove Box, Drop Trunk, Wipers, Radio, FFR Vintage Gauges, Custom Dash
Build Thread:
http://thefactoryfiveforum.com/showt...MK4-Build-9035
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Visit our community sponsor